Zone And Room Number Assignments - LG Pro Centric 32LP645H Commercial Mode Setup Manual

EZ-Manager Wizard (Cont.)

Zone and Room Number Assignments

You may complete one or more of the fields in the Zone, Label, and Room Number screen or
leave them blank, as desired; however, in order to use the Zoning feature on this TV, you MUST
set the TV Zone # as described below. See Reference section, "Using the TV Zoning Feature," for
further information on Zone designations. Note that the Zoning feature is only applicable for TVs
that will be configured for FTG Mode via CPU (using an FTG Configuration [.tlx] file) or for TVs
that will be configured via "Teaching" (cloning) using a USB memory device / .tlx file.
Z
EZ-Manager Wizard
1 4
2 3
Zone, Label, and Room Number
• If creating Zones for Installer Menu settings and/or Channel Mapping, select the appropriate Zone # (0-8)
based on the Zone in which this TV is installed. (See Commercial Mode Setup Guide for more information.)
• Select a Label and/or use the alphanumeric keypad on the remote to input the Room Number.
• When done, select 'Next' to continue.
Zone Label
-----
0
USB Configuration
Exit
1. Complete the appropriate field(s) as described below. Use the Left/Right arrow keys on the
Installer Remote to navigate between each of the fields.
• Zone: Enables you to set a TV Zone # so that the TV can be configured with Installer Menu
and/or TV Setup Menu settings intended only for the assigned Zone. The Installer Menu
and/or TV Setup Menu settings may be provided in a .tlx file to be used either for Teaching
(cloning) or FTG Mode via CPU configuration. If the TV is being configured for FTG Mode via
CPU, the TV Zone # setting also allows the TV to omit channels that have been restricted in
the FTG Channel Map. To set a TV Zone, navigate to the Zone field at the left of the screen,
and use the Up/Down arrow keys to specify a TV Zone # (1–8).
• Label: Allows you to select a North, South, East, or West text label for this TV. In the Label
field, use the Up/Down arrow keys to select the applicable label.
• Room Number: Allows you to specify the number of the room in which the TV is located. In
the Room Number field, you can use the number keys on the Installer Remote to direct enter
a room number. Use the Dash key on the Installer Remote as necessary to toggle between
number and letter characters in the Room Number field. Also, you can use the Flashback key
on the Installer Remote to delete characters in this field.
2. When you are ready to continue, select the appropriate option, as follows:
• To proceed to the next EZ-Manager screen, use the arrow keys to select Next, and then
press OK on the Installer Remote. Continue to the "Configure Pro:Centric Settings" section
on the following page.
• If you wish to use a USB memory device in conjunction with the TV's standard USB Down-
load Menu to complete the configuration, continue to "USB Configuration" on page 17.
• If you wish to use a USB memory device in conjunction with the LG Smart Install utility to
complete the configuration, see "LG Smart Install Utility" on pages 18 to 19.
14
Q.MENU
1 2 3
Room Number
INPUT
TV DVD MARK
1 2 3
4 5 6 .,; @ abc def
4 5 6
ghi jkl mno
7 8 9
pqrs tuv wxyz
7
8 9 0
FLASHBK
CHAR/NUM
CC
P
CHAR/ VOL TIMER CH A
0 DEL G
E
DELETE
NUM MUTE
PORTAL INFO GUIDE
OK
ENTER
Next
Zone & Room Number
MENU
SETTINGS EXIT
PIP PIPCH+ PIPCH-
SWAP PIP INPUT SAP
206-4232