Status Message - Kenwood TK-2170 Instruction Manual

■
I
DENTIFICATION
An ID code is a combination of a 3-digit Fleet number and
a 4-digit ID number. Each transceiver must have its own
Fleet and ID number.
• Enter a Fleet number (100 ~ 349) to make a group call.
• Enter an ID number (1000 ~ 4999) to make an individual call
in your fleet.
• Enter a Fleet number to make a call to all units in the selected
fleet (Fleet call).
• Enter an ID number to make a call to the selected ID in all
fleets (Supervisor call).
• Select "ALL" Fleet and "ALL" ID to make a call to all units
(Broadcast call).
Note: The ID range may be limited by programming.
S M
TATUS ESSAGE
You can send and receive 2-digit Status messages which may
be decided in your talk group. Status messages range from
10 to 99 (80 ~ 99 are reserved for special messages), each of
which can contain up to 16 alphanumeric characters.
A maximum of 5 received Status calls can be stored in the
stack memory of your transceiver. These saved messages can
be reviewed after reception. Depending on your dealer
settings, when the stack memory is full, either the oldest
message will be erased when a new message is received or
the new message will not be stored in the stack memory. The
icon lights when a message is stored in the stack memory.
■
T
RANSMITTING
1 Select your desired zone and channel.
2 Press the key programmed as Status to enter Status
Mode or Selcall + Status to enter Selcall Mode.
• When using the Status key to enter Status Mode, the
station ID is fixed and cannot be selected. Skip to step 5.
C
ODES
25