Samsung SL-C460FW User Manual page 110

Understanding display messages
Message
Calibrating The machine is calibrating
the image density.
image density...
Door Open The cover is not securely
latched.
Close it
Scan Unit Open The scan unit is not securely
latched or paper has
or Exit JAM
jammed in the scanner area.
Door of scanner is The cover of scanner is not
open. securely latched.
Error [error number] The indicated toner
cartridge is installed
Install [color] toner
improperly, or the connector
is polluted.
Error [error number] The machine unit cannot be
controlled.
Turn off then on
Error [error number]
Call for service
Meaning Suggested solutions
Wait a few minutes.
Close the cover until it
locks into place.
• Clear the jam (see
"Clearing original
document jams" on
page 95).
• Close the cover until it
locks into place.
Close the cover until it
locks into place.
Reinstall the Samsung-
genuine toner cartridge
two or three times to
confirm it is seated
properly. Or clean the
connector. If the problem
persists, contact the
service representatives.
Reboot the power and try
the printing job again. If
the problem persists,
please call for service.
Message
Scanner Locked The scanner is locked.
Install TR. The transfer belt is not
installed.
belt unit.
Not compatible The transfer belt of the
machine is not for your
transfer belt
machine.
Not installed The waste toner container is
not installed.
Waste tank
Check Fax Line The fax line is not properly
connected to the LINE port.
Not proper room The machine is in a room
with improper room
temp. Move set
temperature.
Output bin Full The output tray is full. Or the
sensor is not facing down.
Remove paper
Meaning Suggested solutions
Reboot the power. If the
problem persists, please
call for service.
Install a Samsung-
genuine transfer belt.
Install the a Samsung-
genuine part designed
for your machine.
Install a Samsung-
genuine waste toner
container.
Connect the fax line to
the LINE port not to the
EXT port (see "Rear view"
on page 23).
Move the machine to a
room with proper room
temperature.
Remove papers from the
output tray, the machine
resumes printing. Or
make sure the sensor is
facing down. If the
problem persists, call for
service.
4. Troubleshooting
110