Display Assembly - Toshiba Tecra A3-S711 Maintenance Manual

4 Replacement Procedures
Installing the Modem
To install a modem, follow the steps below and refer to the figures in the preceding section.
1. Connect the modem cable to the modem module.
2. Fit the modem into its connector and secure it with two black M2.5x3 screws.
3. Sheet the modem cover and secure with one M2.5x 5 screw.

4.12 Display Assembly

Removing the Display Assembly
To remove the display assembly, first remove the keyboard and wireless LAN, then follow the steps
below:
1. Remove two black M2.5x8 screws from the back side of the computer.
2. Pull the strip cover.
3. Disconnect the wireless cable (1) from system.
4. Disconnect the LCD cable (2) from system.
5. Disconnect the Bluetooth cable.
6. Remove two M2.5x8 black screws securing LCD hinge.
4-28
Figure 4-21 Removing the display assembly screws
Tecra A3/S2 Series Maintenance Manual