Toshiba Tecra A3-S711 Maintenance Manual page 22

1.2 System Unit
Marvell 88E8053 for Giga LAN
PCI Express base specification 1.0a compliant
x1 PCI Express interface with 2.5 GHz signaling
Advanced error reporting
Message signaled interrupts
Configurable 48 KB deep buffer
On-chip VLAN insertion and removal
TCP, IP, UDP Checksum offload
Compliant to 802.3x flow control support
10/100/1000 IEEE 802.3 compliant
Automatic MDI/MDIX crossover at all speeds
Wake On LAN(WOL) power management support
Compliant to ACPI 2.0 specification
Smart power down when link is not detected
Marvell Virtual Cable Tester(VCT) for advanced cable diagnostics
Marvell 88E8036 for 10/100M LAN
PCI Express base specification 1.0a compliant
x1 PCI Express interface with 2.5GHz signaling
Active state power management (L0s) support
Advanced error reporting
Configurable 4KB deep buffer
Message signaled interrupts
Compliant to 802.3x flow control support
10/100 IEEE 802.3 compliant
Wake On LAN(WOL) power management support
Compliant to ACPI 2.0 specification
Smart power down when link is not detected
Power regulator outputs for 2.5V and 1.2V supplies
Marvell 88SA8040 for Serial ATA Bridge
ATA/ATAPI PIO mode data transfer
ATA/ATAPI Ultra DMA(UDMA) data transfer rates of 16.7, 25, 33, 44, 66, 100,
133 and 150MB/s
Serial ATA power save modes
Serial ATA hot-plug
Enhanced receiving FIFO flow control for Serial ATA link
DMA Command Queuing(maximum 32 entries
Supports 20, 25, 30, or 40MHz reference clock.
Serial ATA Interface of 1.5Gbps
Full scan for high production test coverage
Tecra A3/S2 Series Maintenance Manual
1 Hardware Overview
1-13