Changing The Priority Channel Data Pickup Channel; Changing Priority Interval Time - AOR AR8200 Manual

This is accomplished by using the "PRIO SET" menu accessed by
the key sequence
The legend "PRIO SET" appears on the top line of the LCD to
confirm selection.

6-2-1 Changing the priority channel data pickup channel

Should you wish the priority channel to use data contained in another memory location, access the
"PRIO SET" menu using the key sequence
appears on the top line of the LCD to confirm selection.
Select the new location for data pickup by the priority channel, use the main dial to move through the
memory locations one at a time or use the
a three digit memory location via the keypad.
For example, select memory location "A23" using the key sequence
The priority interval time menu may be accessed using the
The newly nominated channel data will be used for priority monitoring.
Note: If you attempt to nominate a channel which contains no data, the input will be
ignored and the previously used data will continue to be employed.

6-2-2 Changing priority interval time

Should you wish to check the priority frequency more or less often, the sampling time (interval) may be
set using the "PRIO SET" menu. Use the key sequence
"PRIO SET" menu.
Use the main dial to vary the interval time in increments of 1 second, the
the interval time in increment of 10 seconds. Priority time may be varied between the range of 1s to 99s.
the
The more often you check the priority channel, the greater chance you have of 'catching' activity,
however the greater the interruption to normal monitoring.
to accept the input and exit the menu.
Note: Priority interval time is also used for VFO SCAN timings.
.
the key to move the cursor to the "INTERVAL" input line.
key to act as a short cut to 5 seconds (default).
.
keys to move between banks, alternatively quickly key in
key or
Section 6-2, 6-2-1, 6-2-2
, the legend "PRIO SET"
to exit the menu.
to access the
keys may be used to vary
61