Table of Contents
Advertisement
After applying the changes, the DisplayLink device will need to be disconnected and reconnected to the USB bus
before the settings take effect.
Wake on LAN will wake the PC from an S3 (suspend or sleep) state. It may fail if the PC turns off the USB connection
during S3 on battery power. It will not wake the PC from an S4 (Hibernate) or S5 (Off) state.
6.7.
Configuring Ethernet settings remotely
This section is designed for IT administrators only to allow them to remotely set Ethernet parameters. This section
should only be followed if you are an advanced user, familiar with the Windows registry.
It is possible to set the Ethernet options remotely through the Windows registry on the PC. The settings are stored
under:
HKEY_LOCAL_MACHINE\SYSTEM\CurrentControlSet\Control\Class\{4D36E972-E325-11CE-BFC1-08002bE10318}
There is a list of numeric keys under here, starting at 0000. Each of the keys are the settings for a network card. This
can be found under the details tab, under the Driver Key properties. In the example below, it is 0022:
© DisplayLink 2013 – Issue 1
DisplayLink USB Graphics User Manual
Software Version 7.4
Page
31
Advertisement
Table of Contents
