Setting The Displaylink Display To Mirror The Primary Screen; Setting The Displaylink Display As The Primary Display - DisplayLink USB Graphics User Manual

For more detailed mode setting, including the refresh rate, click Advanced Settings button, then the Adapter tab then
on the List all modes button. All valid combinations of resolution, colour quality and refresh rate are listed. For CRT
monitors, it is best to use a high refresh rate so as to avoid discomfort due to flicker. Flat panel monitors do not flicker
and a low refresh rate is adequate.
To set the display to Extend Mode using the DisplayLink menu
1. From the taskbar, click on the DisplayLink icon
2. Select Extend.
5.6.2.

Setting the DisplayLink Display to Mirror the Primary Screen

Mirror mode copies what is on the main display and reproduces it on the secondary display.
To set the display into Mirror Mode
1. Uncheck the Extend the desktop onto this monitor checkbox
2. Click Apply.
To set the display into Mirror mode using the DisplayLink menu
1. From the taskbar, click on the DisplayLink icon
2. Select Mirror
Note: The display resolution of the primary display and the DisplayLink display may be changed to a lower resolution.
In mirror mode, both screens must output the same resolution, which may not be the maximum resolution of the
display.
This mode is NOT recommended if using the DisplayLink display as the primary laptop display, as it is unlikely to
provide the optimum resolution for the DisplayLink display. Please see,
Display.
5.6.3.

Setting the DisplayLink display as the Primary Display

To make the DisplayLink USB Graphics the Primary Display
1. Select the This is my main monitor checkbox
2. Click Apply.
Note: On some PCs and laptops it is necessary to disable the main display (clear the Extend the desktop onto this
monitor checkbox for the main display) as part of the same settings change. The reason for this is that many primary
graphics card drivers tend to make the laptop screen primary if it is enabled. The only workaround for this is to disable
the laptop screen to allow another screen to be primary. To do this:
1. Select the This is my main monitor checkbox
2. Select the primary display (Display 1).
© DisplayLink 2013 – Issue 1
DisplayLink USB Graphics User Manual
Software Version 7.4
(1 in Figure 1).
(1 in Figure 1) of the DisplayLink display.
.
(1 in Figure 1).
.
Setting the DisplayLink display as the Primary
Page
24