Configure Wake On Magic Packet Only - DisplayLink USB Graphics User Manual

Software version 7.4
Table of Contents

Advertisement

Note: This option will be greyed out if not supported by your PCs USB Host controller or BIOS.
Wake on Magic Packet also needs to be enabled under the Advanced tab:
The DisplayLink device will need to be disconnected and reconnected to the USB bus before the settings take effect.
Wake on LAN will wake the PC from an S3 (suspend or sleep) state. It may fail if the PC turns off the USB connection
during S3 on battery power. It will not wake the PC from an S4 (Hibernate) or S5 (Off) state.
6.6.

Configure Wake on Magic Packet Only

To allow Wake on Magic packet only, also check the option to Only allow a magic packet to wake the computer. Also
Enable Wake on Magic Packet under the Advanced Tab:
© DisplayLink 2013 – Issue 1
DisplayLink USB Graphics User Manual
Software Version 7.4
Page
30

Advertisement

Table of Contents
loading

Table of Contents