To Hoop The Fabric; Slide On The Hoop - Pfaff IEC/EN 60335-2-28 Owner's Manual

To hoop the fabric

For the best embroidery results, place a layer
of stabilizer beneath the fabric. When hooping
stabilizer and fabric make sure that they are smooth
and securely hooped.
1. Open the quick release (A) on the outer hoop.
Remove the inner hoop. Place the outer hoop on
a rm at surface with the screw on the lower
right. There is a small arrow in the center of the
lower edge of the hoop which will line up with
a small arrow on the inner hoop.
2. Place stabilizer and the fabric, with the right
sides facing up, on top of the outer hoop. Place
the inner hoop on top of the fabric with the
small arrow at the bottom edge.
3. Push the inner hoop rmly into the outer hoop.
4. Close the quick release. Adjust the pressure of
the outer hoop by turning the retaining screw
(B). The fabric should be taut in the hoop for the
best results.
Note: When embroidering additional designs on the
same fabric, open the quick release, move the hoop to the
new position on the fabric and close the quick release.
When changing type of fabric, you might need to adjust
the pressure using the retaining screw. Do not force the
quick release.

Slide on the hoop

Make sure that the accessory tray on the embroidery
unit is closed. Slide the hoop onto the embroidery
unit from front to back until it clicks into place.
The marked center point on the design should
match the starting point of the needle. If minor
adjustments are needed use the icons on the screen
(See chapter 8).
To remove the hoop from the embroidery arm,
press the grey button on the hoop connection
assembly and slide the hoop towards you.
B
A
7:5