To Hoop The Fabric - Pfaff creative 3.0 Owner's Manual

To hoop the fabric

For the best embroidery results, place a layer
of stabilizer beneath the fabric. When hooping
stabilizer and fabric make sure that they are smooth
and securely hooped.
1. Open the quick release (A) on the outer hoop.
Remove the inner hoop. Place the outer hoop on
right. There is a small arrow in the center of the
lower edge of the hoop which will line up with
a small arrow on the inner hoop.
2. Place stabilizer and the fabric, with the right
sides facing up, on top of the outer hoop. Place
the inner hoop on top of the fabric with the
small arrow at the bottom edge. If you can see
the hoop size in the lower part of the inner
hoop, you have attached it correctly (C).
4. Close the quick release. Adjust the pressure of
the outer hoop by turning the retaining screw
(B). The fabric should be taut in the hoop for the
best results.
Note: When embroidering additional designs on the
same fabric, open the quick release, move the hoop to the
new position on the fabric and close the quick release.
When changing type of fabric, you might need to adjust
the pressure using the retaining screw. Do not force the
quick release.
Slide the hoop onto the embroidery unit from front
to back until it clicks into place.
To remove the hoop from the embroidery arm,
press the grey button on the hoop connection
assembly and slide the hoop towards you.
7:4
hoop
B
A
C