How To Use Your Touchpads - Interlogix ITI Simon Owner's Manual

How to Use Your Touchpads

Touchpads are used to control the security system from any location within or near your home. They have additional home control
features such as light and appliance control. When using the Touchtalk 2-Way RF Touchpad, beeps and voice feedback will be
heard from this touchpad and not from the Control Panel.
Remote Handheld Touchpad and Touchtalk 2-Way RF Touchpad
SYSTEM
STATUS
ARM
Doors &
Windows
ARM
Motion
Sensors
DISARM
1 2 3
4 5 6
7 8 9
On
EMERGENCY -
P re s s & Hol d B t o h K y
8988G07B.DS4
KeyChain Touchpad
8
SYSTEM STATUS Press once to hear information about your system. See "System
Tests & Trouble Beeps" on page 12.
ARM Doors & Windows Press once to turn the security system protection on for all
protected doors and windows.
Press twice to eliminate the preprogrammed entry delay.
ARM Motion Sensors Press once to turn protection on for all Motion Sensors. Use
when no one is home. This is usually used in combination with ARM Doors & Windows.
Press twice to activate the Latchkey feature.
DISARM Press once and enter your access code using the NUMERIC buttons to turn
security protection off. To subdisarm the system, enter the master access code.
ON Light button
system. You may turn on specific lights and appliances by pressing this button once and
entering the unit number of a light or appliance using the NUMERIC buttons.
OFF Light button Press twice quickly to turn off all lights. You may turn off specific
Off
lights and appliances by pressing this button once and entering the unit number of the
light or appliance.
EMERGENCY Press both EMERGENCY buttons for 3 seconds to cause the system to
e s
call a central monitoring station to report a non-medical emergency.
LOCK Press once to arm doors and windows.
LOCK Press twice to arm doors, windows, and Motion Sensors.
LOCK Press 3 times to arm doors, windows, Motion Sensors, and to activate the
Latchkey option.
Entering your home If your installer programmed the KeyChain Touchpad with no entry
delay, and you armed the system with the KeyChain Touchpad, you must disarm your
system from outside of the home to avoid causing an alarm.
Exiting your home
installer programming) to leave without causing an alarm.
LOCK and UNLOCK Press both buttons simultaneously for 3 seconds to send an
intrusion, silent, or non-medical emergency alarm to the central monitoring station.
UNLOCK Press to disarm your security system.
LIGHT Press to turn system controlled lights on or off.
STAR Press to open or close your garage door, if programmed, or your system may be
programmed to turn on a light using this button.
For any keypress on the KeyChain Touchpad, hold the button until the indicator
light blinks.
(Not for use with Basic Model)
Press twice quickly to activate all lights controlled by the security
You have at least 5 seconds and up to 120 seconds (depending on