Table of Contents
Advertisement
How to Use An Off-Site Phone for Remote Phone Control
You may use an off-site phone to arm/disarm your Control
Panel, toggle lights, check system status, or conduct an audio
session (ask your installer if you have this feature). To gain ac-
cess to the Control Panel:
1.
Call the Control Panel and let the phone ring twice then
hang up.
2.
Wait at least 10 seconds and call the Control Panel
again. You may wait up to 40 seconds before calling
again.
3.
The Control Panel should answer on the first ring. You
won't hear any prompt when the system answers.
4.
Press the * button on your telephone and you will hear
system activated.
At this point you may perform the actions listed in the first
paragraph of this page.
For example, to check system status:
Press * + CODE + # + 1 on your telephone. CODE is any
access code programmed into your Control Panel.
Note: Press * + CODE + 9 to hang up or your security sys-
tem site phone may be busy for up to 90 seconds after
your disconnect.
Note: If you are interactive with your Control Panel and the
panel hangs up on you, the system is calling in a report to the
central monitoring station or a pager, due to an action made
by you or someone at the security system site.
The following table identifies the phone commands to be used
when using remote phone control.
2-Way Voice Audio Session
Model)
An audio session may be conducted from off site. You can call
the security system site and talk to the people present and
they can talk to you using the speaker and microphone on the
Control Panel.
Note: Ask your installer if you have this feature available
to you.
Do the following to conduct an audio session:
1.
Follow the instructions above for Remote Phone Control
to gain access to the Control Panel.
2.
Press * + CODE + 5 on the phone to start the audio ses-
sion.
3.
Press 1 to speak or 3 to listen.
If you press 3 to listen you may notice a 5 second delay
before you can hear the Control Panel's surroudings.
See the following table Audio Session Command Set
for the commands that can be used from an off site
phone.
4.
Press 9 + 9 to hang up.
(Not Included in Basic
Phone Commands for Remote Access
Control Panel Function
DISARM
ARM Doors/Windows
ARM Doors/Windows with
No Entry Delay
ARM Motions
ARM Motions with Latchkey
ARM Doors/Windows and
Motions
ARM Doors/Windows with
No Entry Delay and Motions
with Latchkey
Toggle Lights
System Status
Audio Session
Hang Up
CODE = any access code
Audio Session Command Set
Phone
Button(s)
1
Speak
3 or 6
Listen
7
Extends the session for 90 more sec-
onds
99
Terminates session
Note: If 1, 3, 6, or 7 is pressed, the session time is extended
for 90 more seconds. The panel will sound time out warning
beeps when there are 20 and 10 seconds left of the session.
(Not Included in Basic Model)
Phone Command
* + CODE + 1
* + CODE + 2
* + CODE + 2 + 2
* + CODE +3
* + CODE + 3 + 3
* + CODE + 2 + 3
* + CODE + 2 + 2 + 3 + 3
* + CODE + 0
* + CODE + # + 1
* + CODE + 5 + X (X = a
command from the audio
session command set).
See Table on page 7
* + CODE + 9
Audio Session
7
Advertisement
Table of Contents
