Interlogix ITI Simon Owner's Manual page 15

Step by Step Programming Instructions
Use the following instructions to access the programming but-
tons and programming decals.
1. Open the Control Panel Cover by pressing the plastic
latch on the top of the Control Panel.
When you open the cover you will immediately be
prompted by the Control Panel voice to use the red num-
bered keys to enter your ID.
2. Enter Your Access Code.
The Master access code is 1-2-3-4 when the panel is
shipped. You should change it to a code known only
by you.
3. The system voice will prompt you to begin with the
START MENU. The START MENU is located on the left
side of the upper decal.
The START MENU includes the following buttons:
Add
Delete
Cancel
Test
Clock Set
Press the appropriate button.
4. After pressing a button on the START MENU the system
voice will prompt you to then use the MAIN MENU.
The MAIN MENU includes the following buttons:
Option #
Sensor/Remote
Access Code
Light Control
Press the appropriate button.
Depending on the button you pressed, the system will prompt
you to continue by pressing other buttons on the panel.
How to Change an Access Code
1. Open the cover of the Control Panel.
2. The panel voice prompts you to Use red numbered keys
to enter 4-digit ID. Enter your master access code
using the red numbered keys.
3. The panel voice prompts you to Please select from
START MENU. Press the Add button on the START
MENU.
4. The panel voice prompts you to Select from MAIN
MENU. Press the Access Code button on the MAIN
MENU.
5. The panel voice responds with Master Code, press again
for next access code or DONE to select or CANCEL to
quit. Press the access code button again to hear the next
access code. When you hear the access code you wish
to change press the DONE Button.
6. Enter 4 new numbers using the red numbered keys.
7. Close the Control Panel cover.
How to Delete an Access Code
1. Open the cover of the Control Panel.
2. The panel voice prompts you to Use red numbered keys
to enter 4-digit ID. Enter your master access code
using the red numbered keys.
3. The panel voice prompts you to Please select from
START MENU. Press the Delete button on the START
MENU.
4. The panel voice prompts you to Select from MAIN
MENU. Press the Access Code button on the MAIN
MENU.
5. The panel voice responds with Access Code 1, press
again for next access code or DONE to select or CAN-
CEL to quit. Press the access code button again to hear
the next access code. When you hear the access code
you wish to delete, press the DONE Button. The panel
voice responds with Access Code X deleted.
6. Close the Control Panel cover.
Delete Access Code
Delete
8988G45B.DS4
Options
The following is a table of options you can change. See "What
You Can Change:" on page 9 for a description of these op-
tions.
Option #
1 - Panel Beeps
2 - Panel Voice
3 - Latchkey Time
36 - Sensor Activated
Light Lockout Start Time
(Not for use with Basic Model)
37- Sensor Activated Light
Lockout Stop Time
(Not for
use with Basic Model)
41 - Chime Voice
42 - Speaker Volume
High/Low
(Not for use with
Basic Model)
43 - Pager Phone Number
* See "Option 43 - Pager Phone Number" on page 9
t h e n u s e n u m b e r k e y s t o e n t e r c o d e
Add Delete
On Off
On Off
12am - 11:59 pm Off
12am - 11:59 pm Off
12am - 11:59 pm Off
On Off
High Low
Up to 22 digits* Off
11