Advertisement
Available languages
Available languages
INSTALLATION
Pressure
Washer
Assembly
(Fig.
1)
1. Place handle (0) onto
frame (F) and
secure with saddle bolts and knobs (R).
#,CAUTION:
Risk of persona/injurF,
Avoid
p/acing hands between handle and frame
when assembling to prevent pinching.
2. Attach high-pressure hose (P) to spray
gun. Make sure it is secure.
3. Connect wand (E)to spray gun. Make sure
connection is secure.
4. Place the nozzle holder (B) onto the panel assembly (A) and push
each nozzle holder into place.
5. Remove
the
five
colored
quick-
connect nozzles from
the plastic bag and
insert
them
into
correct grommet on
the nozzle holder. Nozzles are color coded to match colored nozzles
on panel assembly.
NOTE: The high-pressure pump was filled with oil at the factory.
Always check oil level before using (refer to Maintenance
for more
information).
AWARNIN6:
Risk of bursting. Use a tire pressure gauge to check the
tires pressure before each use and while inflating tires; see the tire sidewall
for the correct tire pressure.
NOTE: Air tanks, compressors and similar equipment used to inflate
tires can fill small tires similar to these verb! rapidly. Adjust pressure
regulator on air supply to no more than the rating of the tire pressure.
Add air in small increments and frequently use the tire gauge to
prevent over inflation.
OPERATION
Pressure
Adjustments
The pressure setting is preset at the factoE/to achieve optimum pres-
sure and cleaning. To lower the pressure, follow these instructions.
1. Back away from the surface to be cleaned. The further away you
are, the less the pressure will be on the surface to be cleaned.
2. Change to the 40 ° nozzle (white). This nozzle delivers a less
powerful stream of water and a wider spray pattern. Refer to
Spray Wand Nozzles.
NOTICE:
DO NOT attempt to increase pump pressure. A higher
pressure setting than the factory set pressure may damage pump.
3. Reduce the speed of the gasoline engine (RPM). Slow the engine
down and the water pressure will go down with it.
Spray
Wand Nozzles
(Fig.
1)
The nozzles for the spray wand are stored in the nozzle holder (B)on the
panel assembly (A). Colors on the panel identify nozzle location and spray
pattern. Refer to the following chart to choose the correct nozzle for
the job to be performed.
11
Advertisement
