Table of Contents
Advertisement
1-877-FNA-GAS1 (1-877-362-4271)•www.dewaltpw.com
InstructIon ManuaL
GuIDe D'utILIsatIon
ManuaL De InstruccIones
D
Pressure Washer
Laveuse à pression
Lavadora a presión
If you have questions or comments, contact us.
Pour toute question ou tout commentaire, nous contacter.
Si tiene dudas o comentarios, contáctenos.
INSTRUCTIVO DE OPERACIÓN, CENTROS DE SERVICIO Y PÓLIZA
DE GARANTÍA. aDVertencIa: LÉASE ESTE INSTRUCTIVO ANTES
DE USAR EL PRODUCTO.
Advertisement
Table of Contents
Related Manuals for DeWalt DUMP 0-/2
Summary of Contents for DeWalt DUMP 0-/2
-
Page 1: Pressure Washer
If you have questions or comments, contact us. Pour toute question ou tout commentaire, nous contacter. Si tiene dudas o comentarios, contáctenos. 1-877-FNA-GAS1 (1-877-362-4271)•www.dewaltpw.com InstructIon ManuaL INSTRUCTIVO DE OPERACIÓN, CENTROS DE SERVICIO Y PÓLIZA GuIDe D'utILIsatIon DE GARANTÍA. aDVertencIa: LÉASE ESTE INSTRUCTIVO ANTES ManuaL De InstruccIones DE USAR EL PRODUCTO. -
Page 2: Pump Specifications
FIG. 1 Pressure WasHer Panel assembly Starter grip Nozzle grommets Engine Professional spray gun K. Throttle control lever Wheel L. Choke control Quick-connect Fuel valve lever spray wand Gas cap Frame Handle assembly Engine dipstick/oil plug High-pressure hose Engine switch High-pressure pump Engine Refer to the engine instruction manual for location and... -
Page 3: Specifications
Specifications MoDeL WeIGHt HeIGHt WIDtH LenGtH MaX* aVeraGe GPM MaX* aVeraGe enGIne oPeratInG oPeratInG DXPW3025 85 lbs 26" 22" 36" 3000 3000 HONDA (9.46 L/min) (9.46 L/min) (38.5 kg) (66.0 cm) (55.0 cm) (91.0 cm) (20684 kPa) (20684 kPa) 160 cc OHV * Maximum PSI and GPM ratings determined in accordance with the Pressure Washers Manufacturers Association (PWMA) standard PW101. - Page 4 For est Service land and may also be legally required under other WARNING: Do not operate this unit until you read this instruction statutes and or di nanc es. manual and the engine instruction manual for safety, operation and maintenance instructions. WARNING: This product and its exhaust contain chemicals known to the State of California to cause cancer, and birth WARNING: When using this product basic precautions should...
- Page 5 • Materials placed against or • Never operate pressure near the pressure washer wash er in an area can in ter fere with its proper containing dry brush or DANGER: RISk TO BREAThING (ASPhYxIATION) ventilation fea tures caus ing weeds. WHat can HaPPen HoW to PreVent It overheating and possible...
- Page 6 • Do not allow hose to contact muf fler. • Never attach or remove DANGER: RISk Of fLUID INjECTION AND LACERATION wand or hose fittings while WHat can HaPPen HoW to PreVent It sys tem is pres sur ized. • Your pressure washer •...
- Page 7 DANGER: RISk Of UNSAfE OPERATION DANGER: RISk Of INjURY fROM SPRAY WHat can HaPPen HoW to PreVent It WHat can HaPPen HoW to PreVent It • Unsafe operation of your • Do not use chlorine • High-velocity fluid spray • Always wear ANSI- pressure wash er could lead bleach or any other can cause objects to break,...
- Page 8 • If proper starting procedure • If engine does not start is not followed, engine can after two pulls, squeeze kickback causing serious trigger of gun to relieve DANGER: RISk Of INjURY OR PROP ER TY DAMAGE hand and arm injury. pump pressure.
- Page 9 • High-velocity fluid spray • On pressure washers rated directed at pneumatic tire above 1600 psi (11032 kPa) sidewalls (such as found use the widest fan spray WARNING: RISk Of BURSTING on automobiles, trailers (40º nozzle) and keep the and the like) could damage spray a minimum of 8"...
- Page 10 WARNING: RISk Of ChEMICAL BURN WARNING: RISk Of INjURY fROM LIfTING WHat can HaPPen HoW to PreVent It WHat can HaPPen HoW to PreVent It • Use of acids, toxic or • Do not spray acids, • Serious injury can result •...
- Page 11 4. Place the nozzle holder (B) onto the panel assembly (A) and push NOTICE: DO NOT attempt to increase pump pressure. A higher each nozzle holder into place. pressure setting than the factory set pressure may damage pump. 5. Remove five 3.
-
Page 12: Starting
Chemicals and Cleaning Solvents low pressure applies cleaning metal, concrete, solutions wood or vinyl Applying chemicals or cleaning solvents is a low-pressure operation. Black note: Use only soaps and chemicals designed for pressure washer use. Do not use bleach. to aPPLY cHeMIcaLs anD soLVents * NOTICE: The high-pressure spray from your pressure washer 1. - Page 13 • Your washer operates at fluid pressures and velocities high effort to lower the temperature inside the pump. The thermal enough to penetrate human and animal flesh, which could result relief valve will then close. If pump is left in bypass mode for in amputation or other serious injury.
-
Page 14: Shutting Down
NOTICE: Risk of property damage. Failure to do so could cause 14. As the engine warms up, move the choke to damage to the pump. the OPEN position. 9. Remove all air from the pump and high-pressure hose by depress- 15. -
Page 15: Nozzle Cleaning
Maintenance to cHeck oIL The oil level should come to the dot in the middle WARNING: Risk of burning. When performing maintenance, you of the sight glass (AA). may be exposed to hot surfaces, water pressure or moving parts that can cause serious injury or death. - Page 16 Pump 5. Direct water supply into spray wand to back flush loosened particles for 30 The manufacturer recommends using a pump protector/winter- seconds. izer, such as D WALT winterizer (DP80) when storing the unit 6. Reassemble the nozzle to the wand. for more than 30 days and/or when freezing temperatures are 7.
-
Page 17: Pressure Washer
Pressure Washer WARNING: The use of any other accessory not recommended for use with this tool could be hazardous. Use only accessories rated 1. Drain water from high- equal to or higher than the rating of the pressure washer. pressure hose, coil it and store it Service inForMation in cradle of the pressure washer handle. - Page 18 Glossary LatIn aMerIca: This warranty does not apply to products sold in Latin America. For products sold in Latin America, see country spe- Bypass mode: Allows water to re-circulate within pump when the cific warranty information contained either in the packaging, call the gun trigger is not pulled.
-
Page 19: Troubleshooting Guide
Troubleshooting Guide This section provides a list of the more frequently encountered malfunctions, their causes and corrective actions. The operator or maintenance personnel can perform some corrective actions, and others may require the assistance of a qualified FNA techni- cian or your dealer. Problem code Engine will not start ......................1, 2, 3, 4, 5, 6, 7, 8, 36... - Page 20 (Troubleshooting Codes cont.) coDe PossIBLe cause PossIBLe soLutIon Spray wand not in high pressure. See spray Wand nozzles under Operation. Low water supply. Water supply must be at least 5 GPM @ 20 psi (138 kPa). Leak at high-pressure hose fitting. Repair leak.
- Page 21 (Troubleshooting Codes cont.) coDe PossIBLe cause PossIBLe soLutIon Loose drain plug. Tighten. Worn drain plug O-ring Check and replace. Worn fill plug O-ring. Check and replace. Pump overfilled. Check for correct amount. Incorrect oil used. Drain and fill with correct amount and type of oil. Vent plug is clogged.