Advertisement
Advertisement
Table of Contents
Related Manuals for DeWalt DXPW2000E
Summary of Contents for DeWalt DXPW2000E
-
Page 3: Definitions: Safety Guidelines
IMPORTANT SAFETY INSTRUCTIONS Definitions: Safety Guidelines WARNING: When using this product basic precautions should The definitions below describe the level of severity for each always be followed, including the following: signal word. Please read the manual and pay attention to these Read all the instructions before using the product. -
Page 4: Motor Overload
16. The narrow pin point stream is very powerful. It is not 28. To allow free air circulation, the pressure washer should NOT recommended for use on painted surfaces, wood surfaces or be covered during operation. items attached with an adhesive backing. 29. -
Page 10: Shutting Down
9. Place the motor ON/OFF switch (K) to the ON Position. DXPW2000E DXPW3000E DXPW2500E DXPW2000E DXPW3000E DXPW2500E NOTICE: Risk of property damage. NEVER turn water supply off while pressure washer is running or damage to pump will result. 10. Depress trigger on gun to start water flow. -
Page 12: Pressure Washer
ACCESSORIES NOTE: Using pump guard helps provide proper lubrication to the internal seals of the pump regardless of temperature or environment. Recommended accessories for use with your tool are available for NOTICE: Risk of property damage. Use only SIMPSON ® purchase from your local dealer or authorized service center. - Page 13 This warranty covers defects in material and workmanship and not factory authorized personnel or failure to install and operate equipment parts failure due to normal wear, depreciation, abuse, accidental according to the guidelines put forth in the instruction manual. damage, negligence, improper use, maintenance, water quality or The manufacturer will not be liable to any persons for consequential storage.
-
Page 14: Troubleshooting Guide
Glossary PSI: Pounds per Square Inch. The unit of measure for water pressure. Also used for air pressure, hydraulic pressure, etc. Bypass mode: Allows water to re-circulate within pump when the gun kPa (kilopascal): Metric pressure measurement. 1 kilopascal equal trigger is not pulled. -
Page 15: Troubleshooting Codes
Troubleshooting Codes CODE POSSIBLE CAUSE POSSIBLE SOLUTION ON/OFF switch in OFF po si tion. Place ON/OFF switch in ON position. The main voltage is insufficient, lower than the minimum Check that the main power supply is adequate. required. Extension cord is too long or wire gauge is too small. We do not recommend the use of extension cords with your pressure washer. - Page 16 CODE POSSIBLE CAUSE POSSIBLE SOLUTION Chemical screen not in cleaning solution. Make sure end of chemical hose is fully submerged into cleaning solution. Chemical too thick. Dilute chemical. Chemical should be the same consistency as water. Worn seal or packing. Have parts cleaned or replaced by authorized service center.