Panasonic SCXH70 Service Manual page 23

6.2.4. Service Mode Table 4 (For DVD)
Mode Name
DVD DVD Module P.C.B. firmware version is
Module P.C.B. displayed on the FL Display.
firmware The firmware version can be updated
version display using recovery disc.
Note: It is necessary to check for
firmware version before carrying out
the version up using the disc.
Timer 1 check Timer 1 check
Laser operation timer is measured
separately for DVD laser and CD laser.
FL Display sequence:
Display 1
Timer 1 reset Timer 1 reset
Laser operation timer of both DVD
laser and CD laser is reset all at once.
Timer 2 check Timer 2 check
Spindle motor operation timer
Timer 2 reset Timer 2 reset
Spindle motor operation timer
Item
Description
2.
FL Display
Destination
System controller
generation
Region No.: 0-8
(Display 1)
DVD laser usage time
Shown to the above is DVD laser usage
time, and to the below is CD laser usage
time.
Time is shown in 5 digits of decimal notation
in a unit of 10 hours.
"00000" will follow "99999". (DVD laser)
(Display 2)
CD laser usage time
Time is shown in 6 digits of decimal notation
in a unit of 10 hours.
"000000" will follow "999999". (CD laser)
Time is shown in 5 digits of decimal notation
in a unit of 10 hours.
It will clear to "00000" upon reset.
Time is shown in 5 digits of decimal notation in
a unit of 1 hour.
"00000" will follow "99999".
Time is shown in 5 digits of decimal notation in
a unit of 1 hour.
It will be cleared to "00000" upon activating
this.
23
Key Operation
Front Key
In STOP (no disc)
mode, press [STOP]
button on the main unit,
and [8] button on the
remote control unit.
Cancelled automatically
System
5 seconds later.
controller
version
In STOP (no disc) mode,
press [STOP] button on the
main unit, and [
on the remote control unit.
Cancelled automatically
5 seconds later.
Press [FL Display] button for
next page of FL Display.
While displaying Timer 1
data, press [STOP] button
on the main unit, and [
button on the remote control
unit.
Cancelled automatically
5 seconds later
In STOP (no disc) mode,
press [STOP] button on the
main unit, and [
on the remote control unit.
Cancelled automatically
5 seconds later.
While displaying Timer 2
data, press [STOP] button
on the main unit, and [
button on the remote
control unit.
Cancelled automatically
5 seconds later.
] button
]
] button
]