Using Tls In Vista - ZyXEL Communications NWD-270N User Manual

4.7.2 Using TLS in Vista

Take the following steps to set up WPA, WPA2 or 802.1x security using TLS in Windows
Vista.
1 Either select the AP to which you want to connect in the Site Survey screen (see
4.4 on page
2 In the WPA, WPA2 or 802.1x security screen, select TLS as the EAP Type. Note that
the Login Name, Certificate and Validate Server Certificate fields are greyed-out (not
available).
3 Click Next.
4 In the Summary screen, click Save.
5 A message similar to the following appears in the bottom-right of your screen. Click the
message.
Figure 51 Vista Security: Additional Information Required
6 The Select Certificate screen displays. Select the certificate you want to use in order to
authenticate with the server, and enter your username.
Figure 52 Vista Security: Select Certificate
If you do not have the right certificate, or are not sure which certificate you
should use, contact your network administrator.
7 Click OK. The Select Certificate screen disappears and the NWD-270N tries to connect
to the network. The ZyXEL utility's Link Info screen displays, showing the connection
status (see
connection, you have successfully completed the procedure.
NWD-270N User's Guide
47), or configure a profile (see
Section 4.3 on page 45). If the Link Info screen displays an active
Chapter 4 Station Mode
Section 4.5 on page 53) in the normal way.
Section
63