Steering Friction Adjuster; Power Trim And Tilt Switch On Remote Control Or Tiller Handle - Yamaha F40 Owner's Manual

B
A
If the resistance does not increase even
when the lever is turned to the port side "A",
make sure that the nut is tightened to the
specified torque.
1. Nut
Nut tightening torque:
3.7 Nm (2.7 ft-lb) (0.4 kgf-m)
NOTE:
Check the tiller handle for smooth move-
G
ment when the lever is turned to the star-
board side "B".
Do not apply lubricants such as grease to
G
the friction areas of the steering friction ad-
juster.
EMU26122

Steering friction adjuster

A friction device provides adjustable resis-
tance to the steering mechanism, and can be
set according to operator preference. An ad-
justing screw or bolt is located on the swivel
bracket.
ZMU02810
To increase resistance, turn the adjuster
clockwise.
To decrease resistance, turn the adjuster
counterclockwise.
EWM00040
WARNING
Do not overtighten the friction adjuster. If
there is too much resistance, it could be
difficult to steer, which could result in an
accident.
EMU26141
Power trim and tilt switch on remote
control or tiller handle
The power trim and tilt system adjusts the
outboard motor angle in relation to the tran-
som. Pressing the switch "
outboard motor up, then tilts it up. Pressing
the switch "
tor down and trims it down. When the switch
is released, the outboard motor will stop in its
current position.
NOTE:
For instructions on using the power trim and
tilt switch, see pages 39 and 42.
Basic components
" (down) tilts the outboard mo-
ZMU02908
" (up) trims the
19