Features Memory Storage; Adding A Memory Location - Clarity XL50 User Manual

TELEPHONE OPERATIONS
Receiving a Call
When a call is received, the audible ringer will sound and
the visual ringer will flash to alert you of an incoming call.
To answer the call, lift the handset or use the headset (if a
headset is connected).
FEATURES
Memory Storage
Phone numbers can be stored into the phone's memory
TM
to enable one button dialing. The phone directory allows
space for 10 different phone numbers. One space is
marked to be used to store an emergency number.
LAMP
See Figure 9.
XL50
It is important to not store 911 into your phone.
This will prevent inadvertently calling an emergency
Figure 9
call center. Only store emergency numbers such as a
doctor, hospital, the local fire department or local
police station numbers.

Adding a Memory Location

1. Pick up the handset.
2. Press the PROG button. See Figure 10.
BOOST
3. Enter the telephone number you wish to store.
VOLUME
1 2 3 4
4. Press the PROG button.
5. Press the desired memory location (M1- M9
Figure 10 and Emergency) to store the number to.
6. Place the handset back in the cradle.
Note: No audio notification will occur after the
number has been stored properly.
To change a Memory Location, reprogram using the
same procedure with the button to be changed.
Dialing a Memory Location
1. Pick up the handset.
2. Press the number on the dial pad where the
desired number has been stored.
3. The call will automatically dial.
18
HOLD PROG
BOOST
TELEPHONE OPERATIONS
Lamp Flasher / Bed Shaker Notification
A Wireless Lamp Flasher and Bed Shaker can be
connected to the phone to allow for a variety of ways to
alert the user that the phone is ringing. The Wireless
Lamp Flasher will cause any connected light source
to flash when the phone rings. The Bed Shaker is an
accessory that will begin to vibrate when the phone rings.
This function is only available with the optional Lamp
Flasher or Bed Shaker Notification Accessories.
First connect the Lamp Transmitter to the telephone and
the Lamp Switch to a nearby lamp. See Figure11.
Connect the Bed Shaker to the proper port in the phone
for use. See Figure 12.
Lamp Control
This function is only available with the optional Lamp
Flasher Notification Accessory. This button can be used to
turn on or off the light source to which the Lamp Flasher
is connected. See Figure 13.
E
N
G
L
I
S
H
Figure 11
BED SHAKER
DIAL
P
Figure 12
LAMP
Figure 13
19