Cleaning Procedure - Windsor Clipper CLP12IA Operator Instructions Manual

CLEANING PROCEDURE

Start at wall closest to power outlet. For large
areas flip handle and operate machine in
parallel passes, overlapping brush path. Clean
perimeter last.
During operation, observe the following: The
Clipper is equipped with clear internal covers to
facilitate operator viewing of dirty solution and
vacuum air flow. During operation, observe the
vacuum intake cover. Large amounts of water
or foam entering the vacuum system can
damage the vacuum motor. If you notice either
condition, shut down the machine
immediately. Empty recovery tank and/or add
defoamer to recovery tank.
Use right side of machine for cleaning against
walls.
After cleaning, turn off all controls, return
brush to storage position and carefully unplug
machine.
3-9ENG
OR
STEP
1
STEP
4
VACUUM
INTAKE COVER
STEP
5
STEP
6
OFF
OFF
86038280 04/04/07
SOLUTION
INTAKE COVER
OFF