Advertisement
Quick Links
WINDSOR
OPERATION
04) F
: Hook up vacuum
or spotting
line, solution line, and tool if
necessary.
01) Install jets and brush.
05) Adjust handle for push or pull
cleaning and operator height.
02)
Fill solution tank with extraction
rinse or fresh water and replace
the lid properly. The notch on the
lid should match up with the notch
in the tank.
06) Turn on brush motor.
C
lipper
03)
Make sure that all three prongs
are on the main body of the cord.
i
,
F one oF the prongs is missing
notiFy
. Plug in to outlet and
your supervisor
machine cord and twist to lock.
07)
Starting at the highest set-
ting, adjust brush height set-
ting by setting until you hear
the brush hit the carpet.
Advertisement
Related Manuals for Windsor Clipper
Summary of Contents for Windsor Clipper
- Page 1 WINDSOR lipper 01) Install jets and brush. Fill solution tank with extraction Make sure that all three prongs rinse or fresh water and replace are on the main body of the cord. the lid properly. The notch on the F one oF the prongs is missing...
- Page 2 WINDSOR lipper 08) Turn on the vacuum motor. 09) Choose continuous or intermit- Overlap 2-3” on ever pass, and on intermittent spray release tent spray. Press buttons on button and continue pulling handle to control spray on OPERATION for 1 foot before making a intermittent mode.
- Page 3 WINDSOR lipper 01) Drain recovery tank and 02) Rinse and clean recovery tank. 03) Clean the float shut off. solution tank. MAINTENANCE 04) Clean the brush and 05) i 06) Store brush in the recovery 07) Soak spray jets in a solu-...