Table of Contents
Advertisement
(30cm)
1in.
(25mm)
VACUUM
INTAKE COVER
1ft.
OFF
SOLUTION
INTAKE COVER
CADET 86038340 04/19/07
CLEANING PROCEDURE
STEP
Start at wall closest to power outlet.
1
Pull straight back without pushing
down on handle.
STEP
Release intermittent setting or turn
2
off continuous setting on
brush/spray switch approximately 1
foot before ending cleaning pass.
STEP
Push down on handle to raise
3
vacuum shoe and brush before
moving to the next cleaning pass.
Overlap brush contact area a
minimum of 1 inch on the right
(close cleaning) side of machine.
Overlap a minimum of 2 inches on
the left (drive belt) side of machine.
During operation, observe the following:
The Cadet is equipped with clear
STEP
4
internal covers to facilitate operator
viewing of dirty solution and vacuum air
flow.
During operation, observe the vacuum
intake cover. Large amounts of water or
foam entering the vacuum system can
damage the vacuum motor. If you
notice either condition, shut down the
machine immediately. Empty recovery
tank and/or add defoamer to recovery
tank.
3-8ENG
Advertisement
Table of Contents
