Table of Contents
Advertisement
OPERATIONS
SOLUTION
BRUSH
INT
ON
CONT
3-5ENG
1/8in
(3mm)
CORRECT
INCORRECT
VACUUM
ON
86038280 04/04/07
STEP
Remove electrical cord and literature from
1
recovery tank. Fill solution tank (see filling
instructions).
STEP
Plug cord into grounded outlet. Note: Be sure
2
dome is seated on recovery tank, and float
shut-off is installed correctly.
STEP
Adjust brush to proper setting. Note: For
3
good operation the brush must skim the
carpet. If circuit breaker trips raise brush to
prevent damage to motor or carpet.
STEP
Turn on brush and vacuum motor switches
4
("ON"="I"). Turn on solution switch for
continuous spray or set switch to intermittent
to allow use of trigger switches.
Advertisement
Table of Contents
