Service Procedures (Removal/Replacement) - Garland moisture+ MP-GD-10-S Service Manual

SERVICE PROCEDURES (REMOVAL/REPLACEMENT)

Oven Door Service – Removal / Installation
1 . Disconnect power to unit .
2 . . Locate and remove the 2 machine screws located on the
lower upper LEFT side of the cavity frame . (These screws
are just RIGHT of the lower door post on the cavity door
frame .)
3 . Start to remove this screw . ENSURE THAT THE DOOR IS
SUPPORTED .
4 . Once the screw has been removed, the upper section of
the door can be tilted to the LEFT . Continue to support the
door .
5 . Remove the BA plate screw from the lower oven cavity
bracket .
Part # MPSM07 (03/24/08)
Upper BA
adjustable
door mount
plate
Lower BA
door
support
plate
6 . The upper, and lower door bearing retainers, and door rod
can be easily separated from the cavity with a slight level
pull upward, and to the left .
7 . Reference this sequence in reverse to install, and secure
the door .
Oven Door Light Service / Removal
1 Disconnect power to unit .
2 . Remove the screws holding the door micro switch cover .
This is located on the front LH side of the oven top panel .
3 . Unscrew the upper and lower finger bolts located on the
RIGHT side of the external glass frame to gain access to
the cover housing the oven lights .
4 . Remove upper and lower screws holding the light housing
cover in place .
5 . Remove the required light by pulling up for upper light
and pulling down for the lower light .
Page 57