Explanation Of Controls, (Deluxe Models) - Garland moisture+ MP-GD-10-S Service Manual

EXPLANATION OF CONTROLS, (Deluxe Models)

Programmable Control, (Deluxe Models)
Display
Five distinct areas of the LED display screen are common to
most programming modes and cooking modes:
1 . Upper left corner: displays the programmed temperature
followed by the word SET .
2 . Lower left corner: displays actual temperature currently
monitored by the control, (cavity or probe), followed by
the letters ACT .
3 . Upper right corner: displays time in hours, minutes and
seconds; (00:00:00) .
4 . Lower right corner: displays the word HEAT to indicate
when the burners or the elements are on and heating .
5 . Lower center section: displays the operating mode . While
the oven is idling, this area is blank . During a cooking cycle
it will display COOK . During a hold cycle it will display
HOLD .
Refer to the section entitled DISPLAY MESSAGES on page 23
for additional information regarding display messages and
related button sequenced .
On/Off
Pressing this key once switches power modes, (ON or OFF) .
Light
Pressing the light key will activate the oven interior light for a
period of 30 seconds .
The light can be programmed to turn on for 30 seconds when
the door is opened when the oven is in Cool Down or to come
on when the control is counting down .
Moisture
This key is used to manually activate the moisture function .
It is strongly recommended that moisture only be injected
manually by holding the button for one second at a time .
During a cook cycle that is programmed for moisture, the LED
will light while moisture is injected into the oven cavity .
Moisture can not be manually injected if the fan is running in
Pulse mode .
NOTE: Water can only be injected after the oven has
preheated to at least 225°F (107°C) .
Page 18 Part # MPSM07 (03/24/08)