Operation Instructions; Lighting Instructions; Shut Down Instructions; Adjustments - Garland CG-48F Installation And Operation Manual

OPERATION INSTRUCTIONS

Lighting Instructions

1 . First, make certain that the main power switch is set to
"OFF"
2 . Connect an electrical power cord to 120 volt supply .
 . Turn the gas shut off valve to the "OPEN" position (valve
handle in line with piping) .
4 . Turn the main power switch to "ON", power switch green
indicator should illuminate . Wait until gas pilot, green
indicator illuminates followed by the main burner amber
light indicator .
NOTE: Should pilot ignition fail after a few minutes turn the
main power switch to "OFF" .
Wait 5 minutes, then turn the main power switch back to "ON" .
5 . When the green indicators for their respective zones
are illuminated, set the thermostats to the desired
temperature settings .
6 . The amber burner indicators cycle with the thermostat
operation .

ADJUSTMENTS

NOTE: Each griddle has been factory tested and adjusted
prior to shipment . It may be necessary to further adjust the
unit as part of a proper installation . Such adjustments are the
responsibility of the installer . Adjustments are not considered
to be defects in material and workmanship, and they are not
covered under the original equipment warranty .

Pilot Adjustment

A pilot adjustment valve is located in the line from each
pilot combination valve . Pilot adjustment is accessible from
behind the lower front panel . First remove the two screws
securing the upper front panel to the body, in the upper
right and left hand corners, and then slightly raise the panel
to lift off . Remove to a safe area . Next, remove the two screws
securing the lower front panel to the body, in the upper right
and left hand corners and hinge the panel downwards .
Part # 4520498 (01/08)
Note: During an electrical power interruption, turn power
switch to the "OFF" position . This unit cannot be made to
operate without electrical power .

Shut Down Instructions

1 . Turn main power switch to "OFF" (thermostat dial settings
may be left at their set point if preferred) at the end of
daily operations .
2 . For extended shut down, turn main power switch to
"OFF", close the manual gas shut off valve and unplug the
electrical cord set .
NOTE: Do not waste gas or abuse equipment by leaving
thermostats at a high temperature setting, if not required .
During idling periods, set thermostats to a low temperature
setting . For example 175°F (79°C) to 200°F ( 9°C), to keep
griddle warm . Set thermostats, as required, for periods of
heavy load .
Turning the small screw in the pilot adjusting valve clockwise
reduces the amount of gas provided to the pilot(s) . Turning
the small screw counterclockwise increases the gas provided
to the pilot(s) . The gas should be adjusted to a 7/16 (11 mm)
inch long flame, to ensure that the flame engulfs the top of
the flame sensor .
Burners should always be warm when an adjustment to
air shutters is made . To adjust air shutters, loosen the small
screw along the side of the burner near the orifice . Lifting
flames on the burner indicates too much air and this air
shutter should be in a more closed position . Yellow tips on
the flames indicate not enough air and the air shutter should
be in a more open position . When the air shutter adjustments
are complete on each burner, retighten the air shutter screw
so that the correct setting is locked in place .
Page 7