ATEN CS1708i User Manual page 23

No. Component
1 Port
Selection
Switches
2 Port LEDs
3 Reset Switch Pressing this switch performs a system reset. When the system
4 USB Port
5 Firmware
Upgrade
Recovery
Switch
6 Firmware
Upgrade Port
7 Power LED
8 Station ID
LED
Press a button to give the KVM focus to the computer attached
to its corresponding port.
Simultaneously pressing Buttons 1 and 2 for 3 seconds
performs a Keyboard and Mouse Reset.
Simultaneously pressing buttons 7 & 8 on the CS1708i, or
buttons 15 & 16 on the CS1716i, starts Auto Scan mode.
See F7: SCAN, page 38
The Port LEDs are built into the Port Selection Switches. The
ones on the left are the On Line LEDs; the ones on the right are
the Selected Port LEDs:
An On Line LED lights ORANGE to indicate that the computer
attached to its corresponding port is up and running.
A Selected LED lights GREEN to indicate that the computer
attached to its corresponding port is the one that has the
KVM focus.
is reset, the switch beeps, and the port LEDs flash in
succession until the reset is complete. After the reset is
complete you can login again.
Note: This switch is recessed and must be pushed with a small
object, such as the end of a paper clip or a ballpoint pen.
USB peripherals (flash drive, CD-ROM, etc.) plug into this port.
Peripherals can be shared among the connected computers.
During normal operation and while performing a firmware
upgrade, this switch should be in the NORMAL position. If a
firmware upgrade operation does not complete successfully,
this switch is used to perform a firmware upgrade recovery.
See Firmware Upgrade Recovery, page 134, for details.
The firmware upgrade cable that transfers the firmware upgrade
data from the administrator's computer to the CS1708i /
CS1716i, plugs into this RJ-11 connector.
Lights to indicate that the switch is powered up and ready to
operate.
The CS1708i / CS1716i station ID is displayed here. If this is a
single station installation (see page 19), or the first station of a
daisy chained installation (see page 21), the switch has a
station ID of 01.
On a daisy chained installation, the CS1708i / CS1716i auto-
senses its position and displays the station ID that corresponds
to its place in the chain. (see Port IDNumbering, page 25 for
details).
Description
1. Introduction
9