ATEN CS1708i User Manual page 110

CS1708i / CS1716i User Manual
Setting
Language
OSD/GUI Hotkey
Display Mode
ID Duration
Scan Select
Scan Duration
Screen Blanker
Logout Timeout
Beeper
96
Selects the language that the GUI displays in. Drop down the list
of supported languages to make your choice
Selects which Hotkey controls the GUI function: [Scroll Lock]
[Scroll Lock] or [Ctrl] [Ctrl].
Since the Ctrl key combination may conflict with programs
running on the computers, the default is the Scroll Lock
combination.
Selects how the Port ID is displayed: the Port Number alone
(PORT NUMBER); the Port Name alone (PORT NAME); or the
Port Number plus the Port Name (PORT NUMBER + PORT
NAME). The default is PORT NUMBER + PORT NAME.
Determines how long a Port ID displays on the monitor after a
port change has taken place. The choices are: 3 Seconds
(default) and Always Off.
Selects which computers will be accessed under Auto Scan
Mode (see Auto Scan Mode, page 92). Choices are: ALL - All the
Ports which have been set Accessible (see Port Access,
page 99); POWERED ON - Only those Ports which have been
set Accessible and are Powered On; QUICK VIEW - Only those
Ports which have been set Accessible and have been selected as
Quick View Ports (see SET QUICK VIEW PORTS, page 35, and
The I/O Panel, page 105); QUICK VIEW + POWERED ON - Only
those Ports which have been set Accessible and have been
selected as Quick View Ports and are Powered On. The default is
ALL.
Determines how long the focus dwells on each port as it cycles
through the selected ports in Auto Scan Mode (see Auto Scan
Mode, page 92). Key in a value from 0 – 255 seconds. The
default is 10 seconds; a setting of 0 disables the Scan function.
Note: When using Auto Scan from a remote console, the Scan
Duration must be at least 5 seconds to compensate for signal
delay.
If there is no input from the console for the amount of time set
with this function, the screen is blanked. Key in a value from 0–30
minutes. A setting of 0 disables this function. The default is 0
(disabled).
If there is no Operator input for the amount of time set with this
function, the Operator is automatically logged out. A login is
necessary before the CS1708i / CS1716i can be accessed again.
Enter a value from 0 – 180 minutes. The default is 30 minutes. 0
disables the function.
When set to ON, the beeper sounds whenever the port is
switched, when activating the Auto Scan function (see Auto Scan
Mode, page 92), or when an invalid entry is made on an OSD
menu. The default is ON.
Function