Axis 5600 User Manual page 63

Section 5: Setting Up - Windows
62
Using the Microsoft
LPD monitor with
Window NT 3.5x
Basic Setup
Install the TCP/IP
Protocol Stack
This section describes how to set up a Windows NT Server
v3.5 and v3.51 for LPD printing over the TCP/IP protocol, using the
built-in Microsoft LPD monitor.
If you have not already done so, you should perform the TCP/IP basic
setup procedures prior to installing a printer for LPD printing. These
procedures are defined in Assigning an IP address, on page 25 and
onwards.
In the Control Panel, click the Network icon. If the TCP/IP Printing
entry appears, then TCP/IP is already installed. Close the Network
folder and continue with Installing a printer on the next page.
Follow these steps to install the TCP/IP protocol stack:
1. In the Control Panel, select Network.
2. Click Add Software...
3. Select "TCP/IP Protocol and related components" and then
click Continue.
4. Check "TCP/IP Network Printing Support" and then click
Continue.
5. Select path and then click Continue.
6. Click OK in the Network Settings dialog box.
AXIS 5600 User's Manual