Axis 5600 User Manual page 33

Section 3: Basic Installation
32
Using RARP in UNIX
Follow the instructions below to set the IP address using RARP:
1. Append the following line to your Ethernet Address table. This is
typically located in the
<Ethernet address> <host name>
Example:
00:40:8c:10:00:86 npsname
2. Update, if necessary, your host table and alias name databases, as
required by your system.
3. If it is not already running, start the RARP daemon. This is
typically performed using the
4. Restart the AXIS 5600 to download the IP address.
If the host name has not been mapped to an IP address, simply
Notes:
replace the host name entry with the IP address in the example
above.
If you are using IBM AIX, you will probably not have access to a
RARP daemon. If this is the case, you can use either the ARP or
BOOTP methods instead.
AXIS 5600 User's Manual
file:
/etc/ethers
command.
rarpd -a