Table of Contents
Advertisement
C. Connect the hardware solution to your PC
N O TE
14
3 Disconnect any instrument that is connected to your PC and close
all other applications on your PC.
4 Double- click the saved installation file to begin installation.
5 If you do not have any of the prerequisites installed, the
software prerequisite will appear.
Wizard
6 Click OK to begin the installation of the listed missing
prerequisites.
7 Once the above installation has completed, installation of the
Agilent U21210A- BAsed RF Switch Driver Software will proceed as
normal.
8 Follow the instructions on your screen to begin the installation.
9 Click Finish once the installation has completed.
1 Connect the U2121A- 101 board digital IO terminal to the U2121A
terminal block using the interface cable.
2 Connect the power adapter to the RF switch driver board's DC
power jack.
3 Connect the RF switches as below:
i For 8762/3/4 and 8765x- 324 RF switches, connect to any SL1
[1]
to SL5
slot.
ii For 8765x- 024 RF switches, connect to any X1
iii For N181x RF switches, connect to any SV1
Connect only one type of the RF switch to one channel. Do not use multiple
switches simultaneously on one channel.
4 Connect other types of load to general IO, X7
if required. The load voltage is 24 VDC. The maximum load should
not exceed 300 mA per output channel and 3 mA per input
channel.
InstallShield
[2]
[2]
to X5
slot.
[3]
[3]
to SV5
slot.
[4]
[5]
or X8
and X9
U2121A-101 Operating Guide
[1]
[6]
Advertisement
Table of Contents
