Motorola 110502USM001 - Vanguard 60 Router User Manual page 72

Configure LAN Connections
3-22
Parallel SVC Threshold
Range: 0 to 65534
Default: 8000
Description: Specifies the number of outstanding data bytes that triggers the
use of a Parallel SVC. If this number of data bytes was transmitted
without acknowledgment, the receipt of additional data for
transmission triggers Parallel SVC use. If a Parallel SVC doesn't
exist, one is established (if the Parallel SVCs parameter is
configured to a non-zero value). Note that this parameter must be
configured with a value less than the LCON Queue Limit
parameter.
Guidelines: Appears only if the Parallel SVC field is configured to a non-zero
value, or the Encapsulation Type is RFC 877, and parallel SVC
Trigger Mechanism is set to THRESHOLD.
Parallel SVC Port
Range: 0 to 32 alphanumeric characters. Use the space character to blank
the field.
Default: blank
Description: Specifies the port over which the Parallel SVC is established.
Allowable values can take one of two forms. The first is a port
identifier string. For example, to send the Parallel SVC over port
8:
a) Enter the string X25-8.
The other form is a Switched Services Table destination name. For
example, if the port that the Parallel SVCs come up over is a dial
on demand port:
a) Enter the string "New York".
b) In the corresponding entry in the Switched Services Table,
If left blank, the Parallel SVC is established over the same port as
the Primary SVC.
Guidelines: Appears only if the Parallel SVC field is configured to a non-zero
value.
map "New York" to any port string, for example, X25-8.
Configuring a Vanguard Router