Motorola 110502USM001 - Vanguard 60 Router User Manual page 62

Configure LAN Connections
Configuration
Guidelines
Configuration
Matrix
LANView Configuration Matrix
Parameter Displayed
*LAN Forwarder Type
*Bridge-Link
Number
LAN Connection Type
*Router Interface
Number
Encapsulation Type
Next Hop IP Address
Next Hop IPX Node
Number
3-12
When you configure the LAN Connection Table Record, use the following
guidelines:
• The Bridge Link Number must reference a configured Bridge Link.
• If an Autocall Mnemonic is specified, then the entry must exist in the
Mnemonic Table.
• If Billing Records are ON, then a Billing Printer Mnemonic must be specified
in the Mnemonic Table.
• If a LAN Connection is to receive calls, there must be an LCON entry in the
Routing Table.
The LAN Forwarder Type that you select determines the parameters that appear on
the screen. The following table shows a matrix of the allowable combinations. An
"X" means that for the LAN Forwarder Type you configured, there is no prompt for
the listed parameter.
For ROUT LAN
Forwarder Type
ROUT
X
PT_to_PT, GROUP
5 to Maximum
Configurable
CODEX, RFC877,
RFC1294
RFC877 requires
GROUP LAN
Connection Type
Valid IP address in dotted
notation
Not prompted for LAN
Connection Type of
PT_to_PT
Up to a 12-digit number
Not prompted for LAN
Connection Type of
PT_to_PT
Not prompted for
Encapsulation Type of
RFC877
For BRID LAN
Forwarder Type
BRID
5 to Maximum
Configurable
X
X
CODEX, RFC1294
X
X
For BROUT LAN
Forwarder Type
BROUT
5 to Maximum
Configurable
PT_to_PT, GROUP
5 to Maximum
Configurable
CODEX, RFC1294
Valid IP address in dotted
notation
Not prompted for LAN
Connection Type of
PT_to_PT
Up to a 12-digit number
Not prompted for LAN
Connection Type of
PT_to_PT
Not prompted for
Encapsulation Type of
RFC877
Configuring a Vanguard Router