Configure LAN Connections
3-20
Autocall Mnemonic
Range:
0 to 8 alphanumeric characters
Default:
If (blank), this means autocalling is not initiated by this LAN
connection entry; the LAN Connection Table entry at the remote
device must initiate the call.
Description:
Used when this LAN Connection record initiates the autocall.
Guidelines:
• A corresponding entry must be made in the Mnemonic Table.
• If this record is configured for autocalling, then the referenced
Autocall Mnemonic will contain a remote address that this
LAN connection uses in an X.25 call.
• Address must equal the address of the node to which the
remote LAN is attached (the LAN to which you want to
bridge). The LAN Connection Subaddress configured in the
node record is appended to this address to form the complete
called address of an X.25 call packet.
Autocall Timeout
Range:
5 to 255
Default:
5
Description:
Interval in seconds between calling attempts when auto calling.
Boot Type:
Changes to this parameter require a Table and Node Record boot.
*Maximum Number of Autocall Attempts
Range:
0 to 255
Default:
10
Description:
Specifies the number of times the LAN connection attempts to
autocall a remote destination. A value of 0 allows unlimited
attempts.
Boot Type:
Changes to this parameter require a Table and Node Record boot.
Configuring a Vanguard Router