Using The Valet Switch - Omega Excalibur ATV-1000 Manual

The primary function of the Valet Switch is to place your Excalibur security system into
Valet Mode, which prevents it from arming. You will find this useful when stopping at
service stations, having your vehicle serviced, having your car valet parked or while having
your car washed. The Valet Switch, in conjunction with the ignition key, can be used to
disarm the system should your transmitter be lost or become inoperable. The Valet Switch
is typically mounted in the same housing as the LED Status Light. However, some custom
installations may have the Valet Switch mounted in a more hidden location; if so, be sure
your installing dealer indicates the location of the Valet Switch to you to avoid potential
inconvenience.
Normal Valet Mode: This unique feature can be activated anytime the system is
disarmed and allows you to enter the Valet Mode by simply pressing and holding the Valet
Switch, provided the system is not armed. If the system is armed or in the triggered state,
however, the ignition must be turned "on" and then the Valet Switch must pressed within
5 seconds to disarm the system. Once disarmed, it can be placed into Valet Mode.
While the system is disarmed, simply press and hold the Valet Switch for 2 seconds to
activate the Valet Mode. The system will confirm that it is in the Valet Mode by chirping
the siren twice, flashing the parking and interior lights twice, and the LED Status Light will
illuminate steady Red. The security system will stay in the Valet Mode when the ignition
switch is "on" or "off". While in the Valet Mode, although the system will not arm, the
transmitters will still operate the Remote Panic feature, the doorlocks, and trunk release; the

Using The Valet Switch

Page - 13