Silent Arming & Disarming - Crime Guard 250i6 Owner's Manual

Step 3: Within 5 seconds, Press the Valet/Override Switch.
-The activated system will instantly disarm.
When the Valet/Override Switch is pressed, and the system disarms, releasing the
switch will place the system in standby mode. To put the system into valet mode,
simply press the switch and hold it for 3 seconds.
The Status Indicator Light
The Status Indicator Light visually shows the status of the system and also
provides a high level of visual deterrence. The Status Indicator Light can be
mounted in the holder with the Valet/Override Switch, or mounted in a location
where it can be easily seen by the driver, as well as from outside the vehicle.
Status Indicator Light Off = The system is disarmed and in standby mode.
Status Indicator Light Flashing Slow = The system is armed.
Status Indicator Light Flashing Fast = The system has been activated.
Status Indicator Light On Solid = The system is in the valet mode.
Page 16
then reset itself.
• If the optional DM-1 doorlock interface was installed, the
doors will also unlock upon disarming.
Should the transmitter be lost, damaged, or its batteries be exhausted, the Valet
/Override Switch & your vehicle's ignition key may be used to disarm the system
by performing an Emergency Override, which is explained on pages 15-16.
Silent Arming & Disarming
To Silently Arm / Disarm: Press & Release the Transmitter's Small
Button Twice
Should you wish to arm or disarm the system without
the confirmation chirps, simply press and release the
Transmitter Button 3 twice. Using the Silent Arm/
Press &
Disarm operation simply reverses the armed/disarmed
Release
Twice
status of the security system- if the system is disarmed
when the double Button 3 signal is received, it arms;
should the system be armed when the double signal is
X 2
received, it will disarm.
Page 9