Disarming The System; To Disarm The System; Programmable Features - Crime Guard 250i6 Owner's Manual

rearm itself to detect further entry attempts. If a protected zone is still open at the
end of the activation cycle, the system will continue to reactivate itself, for up to six
activated cycles before it resets itself and ignores the violated zone.

Disarming the System

To Disarm the System:

Upon Disarming: • The siren will chirp twice
• The parking lights, if connected, will flash twice.
• The optional starter interrupt, if installed, will disengage.
• If installed, the Status Indicator Light will turn "Off", or, it will
change to flashing rapidly if the system was activated, and
Press & Release the Transmitter's
"Disarm" Button.
THE SIREN WILL
CHIRP TWICE
THE PARKING LIGHTS
WILL FLASH TWICE
(IF CONNECTED)
(or 4 times if alarm has activated)
Page 8

Programmable Features

The Crime Guard 250i6 vehicle security system has 6 programmable features
which allow the system to be customized. The following pages provide a brief
explanation for each feature, and notes its factory default setting. Following these
descriptions are instructions on how to program the features.
• = Default Factory Setting
1. Current Sensing: (•On / Off)
- This feature enables the armed system to be activated should the system
detect a voltage spike or current draw in the vehicle's electrical system.
2. Current Sensing Activation Delay: (•3 Seconds / 3 Minutes)
- Allows the option of a longer delay before activation by current sensing can
occur. This is for use in vehicles with equipment, such as cooling fans, which
stays on for a short period of time after the ignition has been turned off.
3. Confirmation Chirp: (•On / Off)
- This feature allows the arming and disarming confirmation chirps to be
permanently turned off. When these chirps are turned off, exceptions will be
the prewarning chirps, the chirp made when the system is placed into valet
Page 17