Remote Panic Operation; Emergency Override - Crime Guard 250i6 Owner's Manual

Remote Panic Operation

Should you feel threatened or in need of attracting attention, the system can be
activated remotely by using the transmitter. Your system features "Enhanced
Panic", which allows you to activate Remote Panic from either the "Arm" button or
the "Disarm" button. The former leaves the system armed when Remote Panic is
turned off, and the latter leaves the system disarmed when Remote Panic is
turned off.
To Activate Remote Panic:
OR
Hold 3 Hold 3
seconds seconds
Upon Activating Panic:
• The siren will sound.
• If connected, the vehicle's exterior parking lights will flash on and off.
Press & Hold for 3 Seconds the "Arm"
Button OR the "Disarm" Button
THE SIREN WILL
THE PARKING LIGHTS
SOUND
WILL FLASH ON & OFF
(IF CONNECTED)
Page 10

EMERGENCY OVERRIDE-

How to Disarm the Security System Without the Transmitter:
If the system is armed, and in the event that the transmitter is lost, damaged, or
its batteries have become exhausted, the Valet /Override Switch & your vehicle's
ignition key may be used to disarm the system by performing an Emergency
Override.
IMPORTANT: in addition to the inclusion of the Valet/Override and Status
Indicator Light, the Crime Guard 250i6's "ignition input" wire must also be
connected. If the Crime Guard 250i6 was not installed with the Valet/Override
Switch, or the ignition input being connected, the only way to bypass, or turn off the
system is to locate and unplug the control module and siren assembly must be
unplugged from its wiring harness!
Emergency Override:
Step 1: With the system in the armed condition, enter the vehicle via the driver's
door
(be aware that the alarm will likely activate when the door is opened)
Step 2: Using your key, turn the vehicle's ignition to the "On" position.
Page 15
.