Wiring Diagram - Crime Guard 250i6 Owner's Manual

Although the Crime Guard 250i6 can have basic operations without them, the
Valet/Override Switch and the Status Indicator Light greatly enhance the system.
The Valet/Override Switch allows disarming the system without the transmitter
and placing the system into a state in which it cannot be armed. The Status
Indicator Light visually and quickly shows in which state the system is in.
Valet/Override Switch: Use the combination holder, or otherwise use the self-
adhesive pad to mount the Valet/Override Switch in a hidden but accessible
location. The control module and siren assembly's Gray wire must be routed to
the Valet/Override Switch's mounting location.
LED
The upper half of the combination Then, when the upper half holder
holder may be mounted with the is secured, insert the LED and
two screws provided, or, double- mount the Valet/Override Switch
sided adhesive tape using its double-sided adhesive
may be used. tape.
Installation Insert Page 10
Valet/Override
Switch
Snap the combination holder bot-
tom half to the upper half; ensure
that the wires are routed carefully.

Wiring Diagram

See Installation Insert Page 10 for
combination holder instructions
GRAY WIRE - Valet/Override Switch
PINK WIRE - Positive Output for
LED
Ground
BLACK WIRE -
both
Connect To Ground
Black
wires
BLUE WIRE - Negative Instant Trigger
Relay
Optional
RED WIRE - Constant 12 Volts Positive
Starter
Interrupt
ORANGE WIRE - Ground Output While Armed
1 2 3 4 5
1 2 3 4 5
1 2 3 4 5
1 2 3 4 5
1 2 3 4 5
1 2 3 4
WHITE WIRES - Output To Parking Lights
1 2 3 4
1 2 3 4
1 2 3 4
1 2 3 4
Installation Insert Page 3
Shock
Sensor
Adjust
YELLOW WIRE -
Ignition 12
Volts Positive
BLACK ANTENNA WIRE-
Do Not Connect To Anything
- Stretch Out and Secure