Crime Guard 250i6 Owner's Manual page 11

Valet Mode prevents the system from becoming armed. Valet Mode is designed
for situations in which it is not convenient for the alarm portion of the system to be
operational; for example, such as when loaning others your vehicle, or leaving the
vehicle for servicing, maintenance, valet parking, washing, etc.
To Enter Valet Mode:
(System MUST be Disarmed)
- The Status Indicator Light will turn on solid Red and the siren will chirp once to
confirm Valet Mode. Now the system cannot become armed.
To Exit Valet Mode:
- The Status Indicator Light will turn off to confirm that the system has exited
Valet Mode and returned to a "standby" mode. Normal arming operations may
be resumed.
The security system must be disarmed, and the vehicle's ignition may be "On" or
"Off" when entering or exiting Valet Mode. If the system is armed, or activated, if
the transmitter is lost or inoperable an Emergency Override must be performed!
Press & Hold the Valet
Switch for 3 Seconds
Simply Press & Release the
Valet Switch.
Page 14
Remote Panic can be activated anytime, whether the vehicle's ignition is turned
on or off, and has a 60 second duration (regardless of the 30 or 60 second acti-
vation setting) unless a transmitter is used to stop it. At the end of the 60 second
cycle, the system will reset and be in either the armed state (if Remote Panic was
activated by the "Arm" button) or in the disarmed state (if Remote Panic was
activated by "Disarm").
To Deactivate Remote Panic:
Once Remote Panic has been activated, rather than wait for the system to stop
automatically at 60 seconds, the transmitter may be used to stop the Remote
Panic operation. Simply press and release the "Arm" or "Disarm" button. While
pressing either of these buttons will stop the Remote Panic operation, please
note that the system's armed or disarmed status will depend upon which button
was used to activate the Remote Panic in the first place. For example, if the
"Arm" button was pressed and held to activate Remote Panic, and if the "Disarm"
button was used to stop it, the system will revert to the armed state when Remote
Panic is stopped, because the "Arm" button was the one used to activate the
operation.
Press & Release either the "Arm"
Button OR the "Disarm" Button
Page 11