Replacement Transmitters - Crime Guard 250i6 Owner's Manual

Replacement
Replacement or optional transmitters are readily available from the dealer from
which you purchased your system; or may purchased directly from Omega
Research and Development. Transmitters purchased from Omega are $40.00
each plus shipping fees. The proper transmitter for your Crime Guard 250i6
system is Omega's part number #4412-05; or any Omega transmitter may be
identified and viewed on the Internet at "www.caralarm.com".
Transmitters may be ordered from Omega directly by sending a note to the below
address with the desired transmitter's part number (#4412-05 for the Crime Guard
250i6), a legible return address, and remittance of $ 40.00 plus shipping fees for
each transmitter ordered in the form of personal check, money order or credit card
information. Mail these to:
Omega Research and Development, Inc.
981 N Burnt Hickory Road
Douglasville, Georgia 30134
Transmitters
Page 22
Introduction
Congratulations on the purchase of your Crime Guard 250i6 vehicle security
system. It is most important to note that the Crime Guard 250i6 has a unique and
flexible design, which allows the system to be installed in several configurations,
or levels of sophistication, and thus affects the total operations. The exact op-
erations of your system reflect this, and therefore it is most important that this
operations guide be carefully read and referred to. Regardless of how config-
ured, you'll find your system both easy to operate and reassuring in its effective
theft deterrence capabilities.
Some principle components to become familiar with:
The Transmitter: Regardless of how the system is configured, the remote trans-
mitter is used to operate the system. Two transmitters can operate the system,
and two are supplied with the system already programmed to operate it.
Every transmitter has its own unique, invisible code, and thus cannot be duplicated.
The transmitter has four buttons: an "Arm" button, a "Disarm" button and button
3 which can be used, if desired, to arm and disarm your system silently, and to
bypass the built-in shock sensor. The "Arm" and "Disarm" buttons also operate
the Remote Panic feature. Button 3 is also used in transmitter and features'
programming operations. Button 4 Can be used with optional Rec-43 to operate
an auxillary channel.
Page 3
MA_CG-250I6 / REV0 04/09