Basic Sensor Setup - Cisco IPS 7.1 Installation Manual

Basic Sensor Setup

Participation Level = "Full" additionally includes:
* Type of Data: Victim IP Address and port
Do you agree to participate in the SensorBase Network?[no]:
For More Information
For detailed information on the global correlationfeatures, for the IDM refer to
Correlation, for the IME refer to
Global Correlation.
Basic Sensor Setup
You can perform basic sensor setup using the setup command, and then finish setting up the sensor using
the CLI, the IDM, or the IME.
You can perform basic sensor setup using the setup command, and then finish setting up the sensor using
the CLI, IDM, or IME. To perform basic sensor setup using the setup command, follow these steps:
Log in to the sensor using an account with administrator privileges.
Step 1
Note
Step 2 The first time you log in to the sensor you are prompted to change the default password. Passwords must
be at least eight characters long and be strong, that is, not be a dictionary word. After you change the
password, basic setup begins.
Enter the
Step 3
Specify the hostname. The hostname is a case-sensitive character string up to 64 characters. Numbers,
Step 4
"_" and "-" are valid, but spaces are not acceptable. The default is sensor.
Specify the IP interface. The IP interface is in the form of IP Address/Netmask,Gateway:
Step 5
X.X.X.X/nn,Y.Y.Y.Y, where X.X.X.X specifies the sensor IP address as a 32-bit address written as 4 octets
separated by periods, nn specifies the number of bits in the netmask, and Y.Y.Y.Y specifies the default
gateway as a 32-bit address written as 4 octets separated by periods.
Enter
Step 6
a.
b.
c.
Cisco Intrusion Prevention System Appliance and Module Installation Guide for IPS 7.1
B-4
Purpose: Tracks product efficacy
Purpose: Detect threat behavioral patterns
Both the default username and password are cisco.
command. The System Configuration Dialog is displayed.
setup
to modify the network access list:
yes
If you want to delete an entry, enter the number of the entry and press Enter, or press Enter to get
to the Permit line.
Enter the IP address and netmask of the network you want to add to the access list.
For example, 10.0.0.0/8 permits all IP addresses on the 10.0.0.0 network
Note
(10.0.0.0-10.255.255.255) and 10.1.1.0/24 permits only the IP addresses on the 10.1.1.0
subnet (10.1.1.0-10.1.1.255). If you want to permit access to a single IP address than the
entire network, use a 32-bit netmask. For example, 10.1.1.1/32 permits just the 10.1.1.1
address.
Repeat Step b until you have added all networks that you want to add to the access list, and then
press Enter at a blank permit line to go to the next step.
Configuring Global Correlation, and for the CLI, refer to
Appendix B Initializing the Sensor
Configuring Global
Configuring
OL-24002-01