Connecting The Ips 4240 To A Cisco 7200 Series Router; Accessories - Cisco IPS 7.1 Installation Manual

Chapter 3 Installing the IPS 4240 and IPS 4255
Table 3-3
Maximum peak
Maximum heat dissipation
Environment
Temperature
Relative humidity
Altitude
Shock
Vibration
Acoustic noise

Connecting the IPS 4240 to a Cisco 7200 Series Router

When an IPS 4240 is connected directly to a 7200 series router and both the IPS 4240 and the router
interfaces are hard-coded to a speed of 100 with the duplex set to Full, the connection does not work. If
you set both the IPS 4240 speed and duplex to Auto, it connects to the router but only at a speed of 100
and a duplex of Half.
To connect correctly at a speed of 100 and a duplex of Full, configure the interfaces of both the IPS 4240
and the router with the speed and duplex both set to Auto. Also, if either interface is hard-coded, you
must make the connection using a crossover cable.

Accessories

IMPORTANT SAFETY INSTRUCTIONS
Warning
This warning symbol means danger. You are in a situation that could cause bodily injury. Before you
work on any equipment, be aware of the hazards involved with electrical circuitry and be familiar
with standard practices for preventing accidents. Use the statement number provided at the end of
each warning to locate its translation in the translated safety warnings that accompanied this device.
Statement 1071
SAVE THESE INSTRUCTIONS
Only trained and qualified personnel should be allowed to install, replace, or service this equipment.
Warning
Statement 1030
OL-24002-01
IPS 4240 and IPS 4255 Specifications (continued)
190 W
648 BTU/hr, full power usage (65 W)
Operating +32°F to +104°F (+0°C to +40°C)
Nonoperating -13°F to +158°F (-25°C to +70°C)
Operating 5% to 95% (noncondensing)
Nonoperating 5% to 95% (noncondensing)
Operating 0 to 9843 ft (3000 m)
Nonoperating 0 to 15,000 ft (4750 m)
Operating 1.14 m/sec (45 in./sec) ½ sine input
Nonoperating 30 G
0.41 Grms2 (3 to 500 Hz) random input
60 dBa (maximum)
Cisco Intrusion Prevention System Appliance and Module Installation Guide for IPS 7.1
Connecting the IPS 4240 to a Cisco 7200 Series Router
3-5