Installing 1552E, 1552Eu, Or 1552I In The Mounting Bracket - Cisco Aironet 1550 Installation Manual

Chapter 2 Installing the Access Point
Install four M8 x16 bolts (with flat and lock washers) into the bolt holes.
Step 8
Figure 2-12
1
2
Hand-tighten the bolts and the nut (do not overtighten).
Step 9
Adjust the top edge of the mounting bracket until it is horizontal and tighten the bolts and the flange nut
Step 10
(see
Note
Continue with
Step 11
1552C or 1552CU in the Mounting Bracket, page

Installing 1552E, 1552EU, or 1552I in the Mounting Bracket

Screw a M8 x16 bolt (without a flat or lock washer) in the top support bolt hole on each side of the access
Step 1
point (see
pole mount kit. Do not screw the bolt all the way in. Leave a gap of approximately 0.25 inch (0.635 cm).
OL-24247-01
Screw Hole Locations on the Mounting Bracket and Pole Clamp Bracket Assembly
Pole clamp bracket assembly
Access point support bolt
(M8 flange nut not shown)
Figure 2-12) to 13 to 15 ft lbs (17.6 to 20.3 Nm).
The mounting bracket can be adjusted up to 45
poles.
Installing 1552E, 1552EU, or 1552I in the Mounting Bracket, page 2-23
Figure 2-13 or Figure
Cisco Aironet 1550 Series Outdoor Mesh Access Point Hardware Installation Guide
4
3
3
3
Bolt holes
4 Mounting bracket
o
to compensate for tilted horizontal streetlight
2-26, depending on what you purchased.
2-14, depending on what you purchased). These bolts are supplied with
Mounting the Access Point
1
3
2
or Installing
2-23