Cisco Aironet 1550 Installation Manual page 93

Chapter 2 Installing the Access Point
This unit might have more than one power supply connection. All connections must be removed to
Warning
de-energize the unit. Statement 1028
Note
Ensure a 6 AWG ground wire is connected to the access point (see the
Step 2
section on page
Use an adjustable wrench, a 22-mm socket, or the Sealcon S-2200-WR wrench to remove the Ethernet
Step 3
connector plug from the access point (see
Figure 2-34
1
PoE-in port
Note
Loosen the round end of the liquid-tight adapter by turning counterclockwise, but do not remove (see
Step 4
Figure
OL-24247-01
If your access point contains a backup battery pack, you must press the reset button for 10
seconds or more (see the
2-41).
Location of Ethernet Liquid-Tight Adapters (Only Models AIR-CAP1552E-x-K9 and
AIR-CAP1552EU-x-K9)
4
1
For information on data cable entry, refer to
2-35).
Cisco Aironet 1550 Series Outdoor Mesh Access Point Hardware Installation Guide
"Disabling Backup Battery Power" section on page
Figure 2-34 for the location).
5
2
2
PoE-out port
Figure 1-1 on page 1-6
Powering the Access Point
3-10).
"Grounding the Access Point"
6
2-47