Mounting The Access Point; Installation Options - Cisco Aironet 1550 Installation Manual

Mounting the Access Point

When all bolts are hand-tightened, use a 13-mm closed-end wrench or socket to partially tighten the bolts
Step 3
in the tightening sequence shown in
Step 4 Repeat
(0.68 to 0.79 Nm).
Figure 2-6
1 - 6
Mounting the Access Point
This section provides instructions for installing your access points. Personnel installing the access point
must understand wireless access points and bridging techniques and grounding methods.
All installation methods for mounting an access point on any wall surface is subject to the acceptance of
Caution
local jurisdiction.

Installation Options

There are two optional installation kits:
•
•
Cisco Aironet 1550 Series Outdoor Mesh Access Point Hardware Installation Guide
2-14
Step 3 using the same tightening sequence to fully tighten each bolt to 6 to 7 ft lbs
Hinged Cover Bolt Tightening Sequence
5
Tighten the bolts in the numeric order shown, starting with 1.
Strand mount kit—Used for cable strand installations
Pole mount kit—Used for pole, wall, or streetlight installations
Figure 2-6. Tighten each bolt to 3 to 4 ft lbs (0.34 to 0.45 Nm).
1 3
4
2
Chapter 2 Installing the Access Point
6
OL-24247-01