Advertisement
7.
7
Settheconsole assembly f acedownona soft
surface to avoid scratching t heconsole assem-
bly.
HoldtheRightHandrail (95)neartheconsole
assembly. Next,insert t heconsole wireintothe
largeholeintheRightHandrail andoutofthe
topasshown. I f necessary, useneedlenose p li-
ersto pulltheconsole wireout.
Attach the RightHandrail (95)andthe Left
Handrail (notshown) w ithfour#8x 3/4"Screws
(1)(onlytwoareshown). M akesurethat no
wiresarepinched.Startall four Screwsbe-
foretighteninganyof them;do not over-
tightenthe Screws.
95
Console
Assembl,
Console
Wire
Hole
.
Tighten a 1/4" x 1 1/4" Bolt (5) with a 1/4" Star
Washer (33) into the Handrail Crossbar (94) and
the bracket on each side of the console assembly
(only one side is shown).
Remove the wire tie from the console wire.
8
Console
Assembly..
Console
Wir_
Wire
9. Remove the tie from the Cage Nut (88).
Have a second person hold the console assem-
bly near the Right Upright (78) and the Left
Upright (not shown). Connect the Upright Wire
(38) to the console wire. See the inset drawing.
The connectors
should
slide together
easily
and snap into place. If they do not, turn one
connector and try again. IF THE CONNECTORS
ARE NOT CONNECTED
PROPERLY, THE
CONSOLE MAY BE DAMAGED WHEN THE
POWER IS TURNED ON. Then, remove the long
tie from the Upright Wire.
Set the console assembly on the Right Upright
(78) and the Left Upright (not shown). Be care-
ful not to pinch the wires.
9
Console
Assembb
Console
Wire
Long
Console
Wire
9
Advertisement
