Leading In Cables To The Display Unit; Cable Fed From Rear Of Display Unit (Default); Default Cable Clamp Position - Furuno FR-2115/2125 Installation Manual

Leading in cables to the display unit

The cable clamp may be positioned within the display unit (default arrangement),
outside the display unit or at the bottom of the display unit (when using console
mount, for example). When the cable clamp is located outside or beneath the dis-
play unit, use the bottom clamp front plate and bottom clamp rear plate (supplied
with installation materials).
Also, use the shielding foam (supplied) to protect the noise radiation.

Cable fed from rear of display unit (Default)

Nav equipment
(Gyrocompass)
Keyboard
Log
PWR
Cable position in clamp
(Display unit, rear view)
Rubber plug
(D) Rear clamp plate
(C) Signal cable
(Aluminum)
(B) Power clump
(Aluminum)
(A) Rear clamp base
(Display unit, right-hand side view)
Figure 2-12 Default cable clamp position
• Place shielding foam between cables, and then attach foam to aluminum clamps.
• Fill unused clamp holes with shielding foam.
Slave display
Navigation
SCAN
External CRT
* When no log or nav
equipment is installed,
insert rubber plug
(supplied) to the left of
keyboard cable to hold the
cable in place.
Shielding foam
2-8
Hex bolt
M5X12 SUS 2pcs
Hex bolt
M5X35 SUS 2pcs
Hex bolt
M5X35 SUS 2pcs
(Construction of
cable clamp)
Make sure foam contacts rear chassis.
Rear cable entrance
Cable
(Display unit, rear view)
Panhead screw
M4X8
(D) Rear clamp plate
(C) Signal clamp
(Aluminum)
(B) Power clamp
(Aluminum)
(A) Rear clamp base